cre8tive

grinding machine with vacuum cleaner
Voltage:240V/50HZ, 110/50HZ
Grinding power:1500W (2HP)
Vacuum power:1000W
Working width: 430mm Brush speed: 154rpm/m Feature:

 

Go on then, how much?

 

Just checking to make sure what shipping will be and if you get grinding discs inclusive

 

If its reasonable then I might have one but if it's the normal sort of price then it's to rich for my blood

 

View attachment floor grinder and vac.pdf

Well, work out what it would cost for a machine with skirt and a vac,
1. 1*scrubber brush
2. 1*pad driver
3. 4*Diamond sanding disk
4. sanding paper (10'', 40'', 60'', 80'')
D100 resin sanding disk (#50, #100, #300, #800, #1500,#3000)
6. grinding disk

As discussed with cre8tive
you buy a cheap machine, probably high speed, not the right one for the job, then you get a vac to then custom fit also a skirt if you can find one to tape up and hold it there. disks, pad, grinding disc with segments.
What price would that be?
View attachment floor grinder and vac.pdf

 

By the way what do you class as reasonable? A silly price or a price that reflects good value for money?

 

£400-£500.

The buffer I got has a skirt and vac on it. The vac is tiny so I use the hose and connect it to my pre separator and vac.

 

So it's commercially available at that price for all to buy at 4>500?

 

Hopefully

 

If it's that price, I'm in!

 

Problem is that the diamond segments and plate cost that alone

 

What would you expect to pay for the right machine, vac, grinding plate and 4 segments, scrubber brush, pad drive, D100 resin sanding discs) (grit 50. 100. 300, 800, 1500, 3000)

 

I wouldn't have a clue. How much are they?

 

id expect to pay around £1500+ at minimum for all that gear tbh

 

I do like the look of wolfs mambo though

 

and their turbo stripper

 

So if you an buy it for less than that, it would be a good price then?
What i'm trying to do is get the right gear at a good price for you guys that would be interested, if that's not what some of you want, I won't waste my time. I have got a CN45 at a better price than what is available on the net, nails will come at some point.
It takes a lot of work to find these items and a lot of correspondence to get the best cost price and freight to keep the price as best as can be. I'm stacked with fitting just as you guys are but still find time to source these things and put them on the shop.
(not having a dig at anyone just saying it as it is)

 

I know the grief you go through after speaking to you last week. But did you get time to put the stripper blades on the shop? (Joking)

 

had a quick look, but not been finishing until about 9ish most nights.. 7.30 today..
Janser flex blades wasn't it? for the smaller floor stripper?

 

Yes please. Another early finish? Lol