Hi, First time poster and probably really should be paying a pro to do this to save time, stress and my knees! Anyway, Polyflor Loc is the floor and my challenge is how in the hell do I get this cut under the frame and clicked in. Do I need to ignore the click and glue this section (got a few doors. Thanks for any help in advance
Got it clicked on front edge by hammering on the other end with another old bit of tile on join, need to work out how to get it clicked on left tile. Learning slowly....
Polyflor say start at left corner.....FFS I have got it in but cant get to click between tiles, bought a lam bar so will try this. I've got 4 door ways lol
Just been looking again. If I start at the door frame what would this mean? I still need to get the tiles in at 45 degrees
Have you undercut the door frame/architrave? By the time I've explained the method you'll be completely lost
Yes, tile fits in place fine here, its the click mechanism im unable to do. Im thinking shave down the male click and glue this bit...?
You could try to.... take the other board out from the left hand side of the photo lock them both together on the head joint and try and engage the long side plus also cut a small offcut and engage that across the head joints to help it staying together. Good luck
Thanks chaps....I've done as last poster said. Funny as quickstep use glue down for repairing broken click tiles. Not sure about this Camaro loc stuff...probably showing its price a bit and seems slippery too.
That's an option on laminate floors as the pva would bond onto the MDF not sure would work as well on pvc