https://www.ebay.co.uk/itm/Razor-Scraper-Double-Edged-Sticker-Removal-Tool-100pcs-Plastic-Razor-Blades-/401516444992?mkcid=16&mkevt=1&_trksid=p2349...
That's gutting !!
Hi , the boards are normally glued onto the joists . The nails/screws just hold the boards while this sets , adding more screws now will have no...
Do you mean where the screed touches the oak it will draw up the moisture and stain the oak . If so probably best to tape the oak with duct tape....
Not daft , on new builds they use metal stud partitions , walking on the floor causes the beams to deflect which in turn pulls the metal studwork...
Hi , I would try and find the source of the squeak . Bounce on each joist to find rough area then remove the sheet . Check any joist hangers ,...
Hi , if you have any walls directly underneath check them or metal stud walls. Remove the sheet and bounce on the joist you may be able to trace...
Hi , The ply will be an exterior grade support around the perimeter and screw or use D4 adhesive to fix to joists. Probably worth taking a...
Hi , 18mm t&g Caber deck would normally need joists with 400mm centres , 22mm for 600mm . Is there a reason for using 18mm ply ?
Hi , Your new build should have a warranty with Nhbc , labac or other insurers. You will have a two year waranty period for defects . Nhbc will...
You should put a vertical dpm against the outer wall , then as said some insulation. Keep the screws in , not all expanding foams are the same ....
Take the nozzle off and put a bit of polythene over the end and screw nozzle back on . When you want to use it just replace the nozzle .
I think each door manufacturer can set its own maximum gap but the standard is a maximum of 8mm for a fire door and 3mm for a fire door with smoke...
Hi , i my opinion if your looking at comercial works then yes chas would be a start , there are other H&S advisory companies but chas is well...
Could you turn the boards over ?