Jeez :confused:
Looks like heat has discoulured the safety floor. Possible reasons: Underfloor heating too hot for the safety floor or Underfloor heating not...
Drop the Adams and replace with Ulster if you don't already have it.
If the floor is already lacquered in manufacturing , I'm not sure extra Lacquer layers can be applied on top.
Whatever the flooring manufacturer recommends, anything else if you have a failure, the LVT manufacturer will walk away.
Sounds a great shop and you'll be getting a really lovely specification installation. Allowing the shop to supply everything really will put the...
Get a desk mat from an office supply company.
If it's not a spill on the top surface - seems unlikely - then a replacement is about the only option.
Laminate will be fine. The issues with the vinyl maybe from underneath and subfloor contamination or a water leak, assuming the floor was not...
Ask for the exact product and run that past technical at F-Ball/Ardex/Uzin etc. We have had a couple of very shiney screeds that raised our...
The installer should have the equipment to moisture test the floor before any screeding work etc, if they have assumed all was dry etc or measured...
Have you had the subfloor moisture tested? Was the slab a new slab? What type of screed was used in the renovation?
Anything deep and soft will take a bit or a lot of compression in heavier traffic areas, although Ultimate Impressions will take it better than...
Find our from the builders if the slab is an Anhdrite or Calcium Suplphate screed and if it is, has it had the latence ground off it. If it is...
I'm not familiar with the product but just had a quick look at the website, it suggests the product has a pre-attached underlay and that adding an...