Safety gloves while fitting

Discussion in 'Random Chat' started by The Noodle King, Sep 28, 2020.

  1. The Noodle King

    The Noodle King Member

    12
    0
    1
    I've just read the post about latex gloves, but does anyone on here wear safety gloves while fitting, either on one hand or both. only reason im asking is that i cut my bloody finger today pretty deep while i was putting some capping on the wall.
     
  2. merit

    merit Well-Known Member

    7,969
    1,639
    113
    Is rather stop fitting cap and cove


    Sent from my iPhone using Tapatalk
     
  3. merit

    merit Well-Known Member

    7,969
    1,639
    113
    Can’t fit with gloves on. Only take up and oiling or dpm


    Sent from my iPhone using Tapatalk
     
  4. The Noodle King

    The Noodle King Member

    12
    0
    1
    I know what you mean, i've tried wearing safety gloves on work sites before but they are to cumbersome. Bloody finger is sore though haha
     
  5. merit

    merit Well-Known Member

    7,969
    1,639
    113
    Tbf if you get the tight fitting ones and started to use them every day I’m sure you would get use to them


    Sent from my iPhone using Tapatalk
     
  6. merit

    merit Well-Known Member

    7,969
    1,639
    113
    Stanley make some good ones


    Sent from my iPhone using Tapatalk
     
  7. Spacey

    Spacey Super Moderator Staff Member

    6,516
    1,878
    113
    I use dewalt gloves from screwfix I spent years on sights where gloves where mandatory You do get used to them
     
  8. Rugmunching

    Rugmunching Well-Known Member

    3,656
    629
    113
    Wore gloves for over 10yrs now, dont get how some say they are awkward to cut/fit with...unless your wearing boxing gloves o_O
     

Share This Page