Found a good link for Air Nailers http://toolstoday.co.uk/shop.php?sec=ca ... +Nail+Guns I like Makita so goin to look into that one, defo want good make an one with 20 or 22 mm nails. Like with most tools buy cheap buy twice
That would be mine Hitachi NV50AH http://www.toolstop.co.uk/hitachi-nv50ah-wire-collated-coil-nailer-p7599. Technically it uses min 27mm but my supplier PR Flooring in Glasgow gets in 22m nails that fit it. I bought the nailer from them but it's really shot up in price since then from any supplier.
Be careful not to do what I did. I bought a roofing nailer which is very similar but it fires 3mm gauge as opposed to 2mm (or thereabouts). Useless for ply.
No Makita does 22mm after looking, seen one last night that did 19 & 22 think it's called max? It's saved on laptop so will post it later. Like yours sandy but don't want to spend more then £400 really, already have compressed so just need gun. Mike have you tried 22mm in ur gun ?
Looking at getting yours up to now as good price, doin a lot more 9mm ply now too so it would be fine for that. Where do u get your nails mate, are they ring shank
Here is the one i'd found last night, its at the bottom and says it takes 19 & 22 mm called MK238 or Max EN452s which does 22mm http://www.bona1stopshop.co.uk/acatalog ... ducts.html
Any one used this one? It uses 22mm & 25mm Divergent staples http://www.spotnails.co.uk/spec.php3?stock=TS3832
Right then Matt which do you recommend for 6mm / 9mm ply. At present I use a stapler but only puts them in straight so want- Stapler which uses 22mm staples divergent or Coil nailer that does 22mm nails
9mm ply on bad floor boards and cause the 6mm I dont trust The Avator is a picture I took last night at planet hollywood in london, went there then to see blood brothers the play. Great night but 5 hour drive this morning back from essex then to a uplift :roll:
