3mm-2mm

Discussion in 'Vinyl / Impervious floor coverings' started by Andrew70, Jun 22, 2013.

  1. Andrew70

    Andrew70 Well-Known Member

    237
    59
    28
    Doing a fair size job in 3mm karndean and then there having 2mm knight tile in the other room is a wide opening and I no I can bevel the 3mm down a bit and was going pack the 2mm up a bit with a couple of strips of pad felt has any one got any better methods cheers
     
    Andrew70, Jun 22, 2013
    #1
  2. dazlight

    dazlight Super Moderator

    7,207
    1,704
    113
    Can you not put a 10mm design strip between them and under cut the design strip so it fits both sides?
    I have done it a few times.
     
    dazlight, Jun 22, 2013
    #2
  3. tarkett85

    tarkett85 Well-Known Member

    3,183
    484
    83
    1mm feather?
     
    tarkett85, Jun 22, 2013
    #3
  4. Andrew70

    Andrew70 Well-Known Member

    237
    59
    28
    Yep I was thinking maybe a 2.5 mm design trim if they will go for it
     
    Andrew70, Jun 22, 2013
    #4
  5. Floorguy1978

    Floorguy1978 Well-Known Member

    63
    39
    18
    Often thought gradus should make t100 could have used it many a time
     
    Floorguy1978, Jun 22, 2013
    #5
  6. Spacey

    Spacey Super Moderator Staff Member

    6,503
    1,881
    113
    Yes 2.5mm design strip between ! Bevel the 3mm to the strip & the strip to the 2mm tile !
    Amticio can be beveled more coz of the 1mm & 0.7mm wear layer's !
     
    Spacey, Jun 22, 2013
    #6

Share This Page