I'm looking for ideas for running Knight Tile ( 2mm thick ) into Van Gogh ( 3mm thick ) and having a flush finish. I did similar last week by cutting the underlay down on the Van Gogh and beveling the cut edge and tucking it down and it worked fine. This time it's a much longer join ( about 4 mtrs ) and curved. I was thinking of building up under the Knight Tile with tape. Any better ideas? ...only need to find 0.5 to 1mm
I've done your way a few times, think it a good way of doing it. I've also put impact tape 3 times ish under edge of knight tile to build it up and that is also a good way.
No ? Bevel the VG to 2.5 then use a 2.5mm design strip between & bevel that down to 2mm to meet the KT Simples !
