Anyone fitted this stuff? It's 3m thick and only 15m rolls so guessing it's heavier than normal type gear. What's it like to cut?
Yeah fitted loads of it, your right it is heavy but still cuts alright just remember to trim it bit of at a time and don't take a huge chunk off at once otherwise it will be short like I found out haha. If doing long lengths site formed it can split sometimes when pulled back so be careful.
Altro say it with all their gear about using their own adhesives, same as every company I suppose. But if sticking in two part adhesive it ain't coming up unless a major fail so don't see why you can't use something else.
Pencil down the sides of eachdrop then f61 of genimi spray each join apply the altro fix aas normal but leave it short of the join pencil lines 2mm then when the sheets put back into place the contact will keep the sheet flat on the joins as stronghold has a tendency to lift slightly on the joins and when the epoxy is dry it stays lipped making the welds proud and tented, and dont roll it use a 2 x 4 covered in carpet to push it out a roller will push the adhesive into lumps under the sheet
