Can you see a visqueen sheet under the concrete ? Any concrete before 1990 really needs a Dpm I’d say. It’s good if it’s high above the ground...
Do the ardex na build up to get the concrete side smooth. then ardex DPM1c over it. then a fibre compound over the lot at 5mm. But massive...
Would have been better taking the floorboards up and using the 18mm plywood to the joists then overlaying with 6 or 9mm SP101 plywood. Then the...
Try using Tapatalk to post the pictures. Yes floor needs to flat to have a LVT click.
If they haven’t got any bigger and solid then rub down and feather finish over them.
Was all the ufh boards solid before the 1st coat of screed was done ? Was the 1st coat primed before the 2nd coat was done ?
Is the ducting flush to the rest of the floor. You could need some plywood or latex screeding to sort the levels out.
We use the xtraflor moduleo seal now and then but less then 1mm I’d leave it alone
What date was the main screed laid ? Was the underfloor heating then switched on for 30 days? Did the floorlayer do a moisture test ?
Merry Christmas & Happy new year lads. Hope it’s been a good year for everyone and hopefully a better 2025.
I’d be going 9mm Sp101 plywood, 2 coats of feather on the joints sanding down each coat. or sp101 6mm then a fibre compound
Finished Wednesday , xmas do yesterday. In a world of pain now. We are back in 2nd Jan
Check eBay mate and you might get lucky.
You want a high compression strength so go for Mapei trade plan as not to expensive
It’s always been a problem on a lot of LVT Karndean art select is 3mm and a full bevel taking it to 2.5mm edge. but a lot of LVT is 2.5mm...
What rooms you doing ?
Which Van Gogh is it ?
What strips are they ? Can you post some pictures ? Do you have a spare pack of them left over ? For Van Gogh the strips should be 3mm depth
Yes do both if possible.
Brush copydex on each joint. You be better using a heat seamer to do the join.
