Neither both have a higher compression strength than NA Sent from my iPhone using Tapatalk
10mm above the height of the pipes, same for ceramics would need a ditra matting too, fitter should have known better whoever specified it is at...
10mm fibre reinforced screed, Schluter Ditra matting and flexible adhesive and grout, the ply should really be concrete board for tile. Sent...
Asphalt will be your best option but don’t try bonding a solid wood to it Sent from my iPhone using Tapatalk
As you pull them up mark on the back 1,2,3,4 etc in the order you take them out then just reverse it on the way back in Sent from my iPhone...
Nope Sent from my iPhone using Tapatalk
Unclick it all to where you need to, back mark the planks so you know the order they go in and make sure you have some spares for inevitable...
Makes it slightly more susceptible to indenting but will do the job Sent from my iPhone using Tapatalk
Uzin KE66, Ardex LVT adhesive is ok, Mapei’s goes off pretty quickly and hates the summer. Sent from my iPhone using Tapatalk
Depends on the screed but a good rule of thumb is 1mm a day up to 50mm and double for anything over that thickness, ufh needs commissioning before...
Westex makes the best carpet here although it won’t be £30m2 other options would be Ulster ayork Twist and Brintons bell twist, and hard wearing...
Valley isn’t a manufacturer they’re a supplier so it’s carpet to carpet on quality although they do change the manufacturer names to make it...
That’s what I would have recommended, I would usually get Ardex out to spec the prep and get it in writing before doing anything for any job that...
You can get sp101 online you’ll be fine, make sure to moisture test the floorboards and ply before putting them down, same again with the oak last...
To help with soundproofing you need mass and lots of it, without doing the rest of the work they’re a waste of money. Sent from my iPhone using...
8mm deflection is way too much for any click system, go with a glue down most of which have a V groove, you need a Rh% test on the concrete but it...
Personally I’d want to rip the lot up, replace the chipboard with ply, overboard with sp101 fibre screed then put the LVT down, although the...
If you can clean out the glue from the joints (will be a bugger and take a long while) you could salvage some or even most of it. Sent from my...
Maximum width is 7m on a floated floor 8m in length, 60% humidity is too high you want to be between 35-55%, like I said earlier pull up, surface...
That’s why I always say to full bond a t&g, I would personally rip up clean out the glue, surface dpm and screed subfloor then fully glue to the...