Thanks for the advice. Decided to go with the Uzin product suggested by Paul Webb, as it is a 90m2 project with massive implications with a...
You've never had one punch right through a weak spot in the ply?
[ATTACH]
We have been asked to install Karndean to an 18mm chipboard floor which has underfloor heating directly under, and touching the bottom of it. I do...
Has anyone used Ardex AF325 Low Emission Carpet Adhesive as an alternative to F3? How did it perform?
Interested to know why you say this Kev, as its the first time I've heard this? Is it to retard timber expansion at the joins that could part the...
On a serious note, the stringer on an old Edwardian staircase circa 1910 or similar, can run out up to a centimetre between the crotch of the...
And don't forget to work against gravity and electro magnetic radiation by working from the bottom up, and use a power stretcher secured to the...
Here's some dribble for you then: Fit the underlay and the gripper about 5mm short of the stringer, but no more than this. Cut the carpet about...
Stan, I advised four north east of England department stores on installation techniques. Tell me about your trade experience?
No one has a clue what they are doing. Would you net cut against the skirting board in a room? or leave a loop pile without a tuck in a room?
Watch a You tube and become an expert, when others have dedicated years of their working life to become proficient.
But its an extension?
Looks like 6mm ply has been used on top of really bad floorboards with no additional preparation.
What litre capacity or power output compressor is needed for a coil nailer on speedy and continuous use for an hour or so? They range from about 6...
What compressor would I need for an Orion CN45?
Always hammered my ply by hand, but wish to progress to a nailer as I'm starting to do jobs with 15-20 sheets at a time (mostly 9mm but sometimes...
Is there a course available or a YouTube to demonstrate how to use these tools Spacey?