Hi Can any of you guys recommend a decent saw for cutting beading? I have tried mitre saws, hacksaws, Japanese saws, tenon saws Haven't found one that gives a perfect cut & am always trimming excess veneer off with my knife. What do you guys use? Thanks in advance
The best is festool symmetric. Amazing saw. Not cheap though but if you do a lot of laminate it’s worth getting.
You could try making a zero clearance fence for your mitre saw, should prevent tear out on the back and stop those little end return bits flying off
Bosch Fine Mitre Saw by far. Don't make them anymore however so you'd have to get one second hand. I bought two, in case on breaks! Amazing bit of kit
