Border work on herringbone

I do the border first when doing herringbone I know it’s the slower way but I find it better fit is this the correct way or just personal preference

 

Don’t ya find probs with bevelling and peaking from cut I’ve done it with field first then used spatula knife to take burr off top also any wobble in cut shows on border I find

 

Parquet I do border first, still yet to try field first on parquet

 

Usually field first, cutting varies depending on the job ,sometimes guillotine, sometimes plunge saw ,sometimes knife ,sometimes all three

 

I meant cutting border in with straight edge which I find is poor I should have been clearer bud lvt

 

I'm talking about lvt

 

Each to their own, I personally prefer field first then border.
Find it faster

 

I find field first faster but not the better job and I think what’s the point in doing a trade if ya don’t want to be good many times in my career I’ve thought I we’re the bees knees but I’ve realised that even a beginner can teach me something also that there are people far better than me and the more I learn the more I realise the less I know

 

I set field and border but install field then snap it back and install border.

 

Straight lay border I install border first then use unders and overs to scribe field in.

 

Your border is (should be) straight, get the floppy straight edge out jobs a good-un

 

Not really. Theres loads of ways of doing it but each to there own. Once you have a few rows down in the field run the scribe down and done.

 

doing the border first is the wrong way trust me , cant bevel the edge for starters and thats just for starters

 

Why can’t you bevel the edge? We do.