Computer access floors

Discussion in 'Subfloor Preparation' started by Stuart Lyle, Apr 7, 2021.

  1. Stuart Lyle

    Stuart Lyle Member

    21
    0
    1
    Looking for some advice please. Picked up work in an office block and its vinyl over metal covered access panels. I'll need to ply vinyl areas but not sure on what fixings to use. Has anyone fixed onto these access floors before and if so what screes did you use?
     
  2. Neilydun

    Neilydun Well-Known Member

    2,859
    1,212
    113
    I tend to go with 6mm ply, on F3 fixed with a coil nailer. Then feather.
    I think you can use F-Ball fill & Prime ?
     
  3. merit

    merit Well-Known Member

    7,969
    1,639
    113
    6mm ply and coil nailer. May want to get some screws as sometimes the panels are rock hard and the nailer struggles


    Sent from my iPhone using Tapatalk
     

Share This Page