Hi guys . Newbie here with 1st post. Had an issue yesterday. Screeded a floor last week with tradeflow. Had to sand it to get a smooth finish They left heating on so dried too fast to roller flat enough. Then came to fitting full stick LVT had to adjust a few planks and it started removing the glue from the floor.never had this issue before. Hoovered to floor to an inch of its life.. Any advice to stop this happening
Did you vac it after it was sanded or a sweep? Did you add any water to the mix? Some screeds are like that I've found and few of them I've had to prime before adhesive due to how chalky it was.
It was vacuumed , the areas that wasn't sanded were fine.. worth some sort of primer before spreading glue
Usually the case when you open it up, some screeds stay a little chalky. I'd give a 1 part primer to 4 part water and let it completely dry