Going rate...

Discussion in 'Wood' started by Rugmunching, Dec 17, 2020.

  1. Rugmunching

    Rugmunching Well-Known Member

    2,467
    448
    83
    Been asked to do quite a bit of herringbone in the v4, 4 separate areas all 19m2 each.
    I'm ardex 1c'in them all but the fitting m2 rate I'm wondering what the going rate for herringbone wood is?

    Last time I did this type of work I charged £26m2
     
  2. Paul webb

    Paul webb Well-Known Member

    584
    74
    28
    That's about what i charge
     
  3. Rugmunching

    Rugmunching Well-Known Member

    2,467
    448
    83
    Is that with borders?
    I was told that I was cheap o_O
     
  4. Paul webb

    Paul webb Well-Known Member

    584
    74
    28
    Depends on how many ins and outs there are in the room, a lot of the time, it's just as easy putting a border in. Is it the v4 zig zag?
     
  5. Paul webb

    Paul webb Well-Known Member

    584
    74
    28
    The zig zag has beveled edges
     
  6. Rugmunching

    Rugmunching Well-Known Member

    2,467
    448
    83
    Yes the v4 bevelled edge planks.
    Ive always done border first with the engineered wood but was thinking is there a plus to doing the field first?
     
  7. Paul webb

    Paul webb Well-Known Member

    584
    74
    28
    I usually fit the field first, then just run round the edges with a plunge saw and sometimes a router in doorways or cut short runs straight before i fit them, i prefer to run the border pieces through the table saw first, so I'm butting square edge to square edge
     
  8. merit

    merit Well-Known Member

    6,721
    1,462
    113
    I think that’s a fair fitting price


    Sent from my iPhone using Tapatalk
     

Share This Page