No expert in these floors but def looks like some sort of seal thats been put on Sent from my SM-G998B using Tapatalk
Mapei do an lvt grout and is actually very good Sent from my SM-G998B using Tapatalk
I personally wouldnt use a water based screed over marley tiles and the tiles can be removed if done properly Sent from my SM-G998B using Tapatalk
What latex was used. How come they never removed the tiles Sent from my SM-G998B using Tapatalk
Most can be laid on in under 24hrs nowadays Sent from my SM-G998B using Tapatalk
Is there a hallway Sent from my SM-G998B using Tapatalk
If the room is square then its badly set out and installed Sent from my SM-G998B using Tapatalk
So its not straight on the opposite wall either im guessing Sent from my SM-G998B using Tapatalk
Longest wall doesnt always determine where you start. It can depend on the room and would need pics to pass judgement Sent from my SM-G998B using...
So your laying tbem ontop of the tiles Sent from my SM-G998B using Tapatalk
I'd always question why is some ok and some bad. Will the ok parts eventually turn bad. Dig up and start again if it wasn't done properly Sent...
After some advise. Would you say this beveled edge is OK or a fault. Top end is smooth but down the length it's serated. Run your nail down it and...
Only way them gaps are gonna look better is if you close your eyes when walking round your house Sent from my SM-G998B using Tapatalk
It's amtico not sure what you expect [emoji2369] Sent from my SM-G998B using Tapatalk
I think it's prowarm injoist foil system. Something like that anyway Sent from my SM-G998B using Tapatalk
I thought about cement boards but there are various places where there's ridges and undulations. Is it possible to screed over as the foil parts...
Sorry half is floorboards. Half is chipboard. Sent from my SM-G998B using Tapatalk
Screwdown chipboard looks like. Sent from my SM-G998B using Tapatalk
Plumber has put this water unfloor heating system down and left it to us to sort out. What's best way to prep this. Its 25 mm lower than the 3...
Really should start to name and shame these companies Sent from my SM-G998B using Tapatalk
