I'm looking at installing a retrofit "wunda" type UFH system and looking to lay 15mm engineered parquet as the finished floor. Each block is 450mm...
Folks, Need to raise the level of a floor by 12mm and have a load of 11mm OSB to hand. Subfloor is 18mm chipboard screwed to joists What's the...
Hi Guys, I am installing UFH but once the wood floor goes down, it's going to raise the floor height by around 25mm if I install over the existing...
Seen a few videos (USA) where they recommend using thinset/tile adhesive rather than using a feather edge over ply and chipboard for levelling up...
Need advice on how to cut a border round a bullnose stair linke in the image below but without the line inset . Struggling to find anything on YT....
I'm installing some herringbone by Atkinson Kirby next week and when I opened one of the packs to get some boards for a dry test run, there were...
that you should nail down and/or glue t&g to chipboard floors? Reason I ask is because we've just had a fitter from a local retailer in to...
I have an 18mm chipboard subfloor, over 400 centres which was installed in the 80s. The CB is sound and I'm about to lay 12mm ply over it then...
Hi Folks, I have installed lots of floors over the years (not a pro but quite experienced). I am currently having horrendous problems with an...
