Hi, following on from a big screed pour of 90m2 at 15mm over ufh, I’m looking to set up and order our Amtico, in small parquet. Think it would...
Just wanted to thank you all for your help and advice on my first big screed. Done 90m2 with Mapei renovation screed and it went down a dream....
I’ve purchased a cam gauge screed rake new from a seller on eBay. Keen to give it a go when we pour next week. Thanks for the advice [emoji1303]...
Hi, does anyone know if you can mix Amtico spacia colours with signature colours? Planks side my side in the same room? I understand the wear...
Lovely thanks Sent from my iPhone using Tapatalk
Can you explain laying semi wet? Assuming that’s also rolled? Thanks Sent from my iPhone using Tapatalk
Did you use Amtico ht or something else? Wet set? I have a friend who has Amtico ht and we thermal gunned his floor last summer at 40 degrees in...
Yeah I was told to do it in one coat. As we’ve discussed on here, I’m doing it in two. Good to know about the first pour getting the pipes set and...
I’m looking into these at the moment - thanks Sent from my iPhone using Tapatalk
To be honest it looked flush until I ran a spirit level over it, but 2 or 3 mm is a lot when the screed is already thin. Sent from my iPhone...
Hi Lisa, I’m about to cast a screed over wundatherm boards and I was very curious to know about the Mapei instructions regarding m2 per bag @ mm...
I’ll have a look at the Midwest rake, point taken about the wolff rake. I’ll abandon that idea - thanks. I’ve done screeding a few times before,...
Hi, I’m about to screed 10mm Mapei renovation over our ufh grooved aluminium boards and ufh pipes. I’ve decided on advice here to screed 6mm then...
Is it possible the screed wasn’t entirely dry before the LvT was laid? Or the pipes not pressurised perhaps? Sent from my iPhone using Tapatalk
Hi Merit, I’m about to lay the same system but on a first floor. I was advised by quite a few people that a floating floor would be a bad idea due...
Paul - have you ever had an issue with the xps aluminium reacting with the cement in the screed? I’ve been warned about it. Apparently the primer...
Fantastic. Thanks for all your help. Sent from my iPhone using Tapatalk
This makes much more sense! Get one base coat on of 6 - 8mm to cover the pipes. Let that go for a week, then get another thinner on top with...
Well one rep previously from instarmac, suggested it was fine to pour in two. I did figure that if the primer was tested to prime the aluminium...
I asked the reps from both Mapei and instarmac about laying in two goes as to me that’s way easier. They suggested that might form a weakness in...
