Cheers guys, haven't used rewmar products before but might give them a go. Seem good value and sounds like they're decent? Not sure I can get them...
Got an engineered floor to put down next week (glue-down), concrete sub-floor that is below 65% RH but was planning putting down a DPM as a...
Haven't got figures to hand Matt, but equilibrium was about 11% from memory. Turns out the air bricks are just above ground level and no evidence...
Got a job that I'm meant to be doing in a few weeks, laying engineered floor on existing softwood floorboards (floating on an underlay). Measured...
I've also got cn45 from betco, never had any problems with it. Got a bambi ht15 compressor which is quite pricey but decent capacity and a lot...
Looking at getting a new orbital sander as part of my floor sanding kit, currently using a fairly cheap Bosch one but time for an upgrade. A lot...
Got it sorted with extra weight, plus I was using wrong drive disc to start with which didn't help Sent from my iPhone using Tapatalk
Am I ok to use ringshanks for 12mm ply? Normally use them for 6mm but have got a floor that needs raising to match adjacent room and was thinking...
Yeah that's the one I was looking at but went for a menzer in the end. Still getting the hang of it, been thrown against the wall a few times o_O...
Yeah that's what I've quoted for, not cheap though for 40m2. Thanks for the advice
Yeah makes sense, now you mention it I I think that's what Matt said when I did one of his courses last year- clearly wasn't listening closely enough
Ok thanks guys, was planning on putting a dpm down but wanted to check if that's what others usually do when there's no dpc. Looking at some...
Hi guys, I've got an engineered install to do on an old concrete subfloor that has no dpc. Haven't taken moisture readings yet but wondering if...
Anyone know if the Numatic 1515 sander/buffer is any good? £684 +vat including dust skirt and extraction system so seems good value. Also if...
If the bevels in engineered floor are too deep to sand out (or to avoid removing too much of the floor) what tool do people use for scraping the...
Cheers guys. Thought I'd posted this reply ages ago but didn't seem to work. Sounds like most people just use cheap ones and accept they don't...
Hi Daz, bit of a mix so far. Did an elka solid a couple of weeks ago and got a bamboo one lined up next week. Quite a bit of sanding recently too
Which blades do people recommend? Mainly for undercutting architrave etc so wood with nails in. Tried a few but just wondering what others use and...
Hi, just registered with the site. Recently started fitting wood & laminate floors as well as doing sanding, so I'll be pestering you lot for...
