I do skirts on nearly all my wood and laminate jobs, either remove and refit or new,when I remove skirts, i will usually prise them upwards first,...
I hate it when you take a toilet out, not knowing that the customer had taken a dump just before you got there, takes your breath away
I tried a pointed one years ago, didn't like it, i use a cam rake or a 16"×31/2" trowel for smaller areas
It's not just the convenience of someone else ordering, it's the service, the guarantee, the ability to make your choice based on more than just a...
The best job would be to glue all over, just sticking the perimeter may cause the vinyl to bubble in the middle, which is a pain to rectify,...
Have you had a look at quantum, morleys and gradus
Me and my half thumb would agree with that
You could try pinpointing whereabouts it creaks, then putting extra scews in that area, but use longer screws
There is everything needed to set 1-2 people up in a sanding business including wire brushing equipment that cost £2500
Thinking about selling my sanding equipment, there is over 20k worth, looking for about 10k,just wandering if there is any interest
They're great for when you're working in an older house and you know there are going to be lots of nails in the frames
Anybody use a bepo?
I've got a fein 18v cordless, had it about 6 or 7years, gets loads of use, just had one repair (was a circuit board or something),expensive tool,...
They're not bubbles, they're air cushions to make it softer,honest
Depending on the condition of the floor, it might be worth looking at having it ground flat I've never used a metal feature strip, but i would...
Your right, nailing through the dpm is a definite no, screeding up to the kitchen shouldn't be a problem, just batten behind the unit legs to...
What kind of dpm are you planning on using under the ply?
Sorry, the silicone comments were sarcasm, as there shouldn't really be any, suggestions on how to fix it are difficult without knowing the actual...
If the same product has been refitted on the same subfloor with probably the same adhesive and is fine, then i'd probably say the issue was with...
Was it a different fitter who refitted part of it?
