Stapler not firing correctly

Discussion in 'Random Chat' started by William143, Jun 28, 2020.

  1. William143

    William143 New Member

    4
    0
    1
    Can any one help me I have a maestri eletric stapler it fires but staples dont go all the way in I've checked if theres any staples jammed but there isn't any advice would be great
     
  2. Jasper

    Jasper Well-Known Member

    103
    38
    28
    try a drop of oil first on the plunger
    Iv stripped mine down before to find a staple caught up in the plunger assembly
    they are quite easy to strip down and put together
    you can also turn the plunger 190 degrees as they can wear on the edge
    Hope this helps
     
  3. William143

    William143 New Member

    4
    0
    1
    Thankyou jasper where is the plunger located
     
  4. William143

    William143 New Member

    4
    0
    1
    Took all apart oiled it up but still not going all the way through
     
  5. Rugmunching

    Rugmunching Well-Known Member

    3,649
    627
    113
    It could be a piece of the driver blade end snapped off. I've had couple staplers where this has happened before, also had to replace the driver on my tacwise for same reason
     
  6. William143

    William143 New Member

    4
    0
    1
    Thankyou much appreciated
     
  7. dazlight

    dazlight Super Moderator

    6,828
    1,614
    113
    Send it to spotnailers for a service.
     
  8. Spacey

    Spacey Super Moderator Staff Member

    6,516
    1,878
    113
    buy a new one
     
  9. mjfl

    mjfl Well-Known Member

    6,258
    1,593
    113
    Never ever put oil in them. It may need a new driver blade washer that comes in with a service kit.
     

Share This Page